Samson 3310, Mounting And Operating Instructions

Page: 58 / 80

9-12 EB 8222-1 EN
Service and conversion work
Final work
a) Versions with PTFE soft seal
(S), PEEK soft seal (S) and
Enhanced metal seal (E)
The seat ring must be slightly pushed further
inwards. To do this, open and close the seg-
mented ball with equal percentage side (%)
two or three times.
b) ARCAP
®
metal-seated version
(A)
See Fig. 9-7
Î
If the initial breakaway torque required
to open the valve is too high, the wash-
ers (23) in position B (between the metal
tubular seal and retainer) press with too
much force against the segmented ball.
In this case, change the position of the
washers (23) from position B to A (at the
seat in the valve body).
Î
If the seat leakage is too high, the wash-
ers (23) on the seat in the valve body
(position A) are not pressing with suffi-
cient force against the segmented ball. In
this case, change the position of the
washers (23) from position A (at the seat
in the valve body) to position B (between
the metal tubular seal and retainer).
9.5.3 Replacing the
segmented ball, valve
shaft and bearings
Risk of control valve damage due to incor-
rect servicing.
Î
To replace segmented ball, valve shaft
and bearings, contact our after-sales ser
-
vice.
9.6 Ordering spare parts and
operating supplies
Contact your nearest SAMSON subsidiary
or SAMSON's After-sales Service for infor-
mation on spare parts, lubricants and tools.
Spare parts
See Annex for details on spare parts.
Lubricant
See document
u
AB 0100 for details on
suitable lubricants.
Tools
See document
u
AB 0100 for details on
suitable tools.
NOTICE !