HDV
Routing switchers
elektronik
Sams elektronik d.o.o. • [email protected] • www.sams.rs
24
INITIALIZATION
Pressing button Chage Control Panel window opens to configure additional commands.
At the time of opening, the program communicates with the commands, searching, which has an
address 1. During this time, all the buttons in the window are locked.
ADDRESS
If there is a command at the address 1 in the window will show that it is a command. The names
of sources and destinations that have been renamed in the main window will be displayed in the
configuration of slave command. In the case shown in the figure that is an slave command CP-48
(48x1). If the software is detected at this address, it will display the command in the menu Panel Type,
which is then locked for a change. If the software does not find the remote control at that address, Panel
Type menu is unlocked and can then be selected type of command.
ICONS:
- LOAD FROM FILE: Loading a previously configured panel that is recorded as a document
on your computer.
- SAVE TO FILE: Saving configuration of slave command as document on your computer.
- LOAD FROM PANEL: Loading current state of addressed remote control for further
configuration.
- PANEL TYPE: Selecting the type of remote control.
- PANEL ADDRESS: Selecting the addresses of slave control.
- WRITE TO PANEL: Saving the configuration in remote control.
- SOURCE BUTTON: Source buttons of selected remote control.
- DESTINATION BUTTON: Destination button of selected remote control.
