Sampo SR1046PRO, Instruction Manual

Page: 59 / 101

- 59 -
SR 1046PRO
44
45
46
instruction manual
H
arv es t er
2/2012
2. Changing of the oil in the final drives
Clean around control opening A, breather
B and oil drain C. Remove the protective
plugs and drain the oil into a pan. Remove
and clean magnetic plug D. Refit the magne-
tic plug and oil drain plug and pour the oil
through the breather. The oil level should
come up to control opening A. Refit the
cleaned breather and control plug.
Used oil is problem waste, which shall be
disposed of in an appropriate manner.
Use an oil type in accordance with the oil
table. The right-side final drive holds approx.
5.2 litres and the left-side one approx. 5
litres of oil. See fig. 44.
A Control Opening
B Breather
C Oil Drain Plug
D Magnetic Plug
3. Changing of hydraulic oil and filters
Traction and working hydraulics have a
joint oil tank. Oil should be changed at least
once a year. Before changing the oil, run the
system until it is warm and adjust all the
cylinders in their shortest position.
Oil is drained from the system by unplug-
ging the drain plug at the end of the drain
hose. Have a sufficiently large pan handy,
as there is approx. 100 litres of oil. Clean
around the filters carefully before removing
them.
N
ote
!
The oil does not need to be drained
when the filters are changed.
When changing the suction filter, turn the
filter cover counter clockwise. Quickly turn
the filter cartridge out to make the flap valve
inside the filter close, which prevents more
than the filter volume of oil from leaking
from the tank. Turn the plastic plug at the
bottom of the filter off and replace the filter
cartridge, fig. 45.
The pressure filter is replaced by turning the
bottom of the filter off, after which the filter
can be replaced by hand, fig. 46.
To change the return filters, unscrew the