Sampo SR1046PRO, Instruction Manual

Page: 64 / 101

- 64 - - 65 -
SR 1046PRO
instruction manual
H
arve st er
2/2012
Summary of periodical procedures
The summary always includes checks and service performed at shorter intervals. For more
detailed crane and harvester head service instructions, see the respective manuals.
Daily or every 8 hours:
1. Check the engine oil level
2. Check the radiator coolant level
3. Check the hydraulic oil level
4. Lubricate the points to be lubricated
daily
5. Clean the coolers and the grille
6. Check the tyre air pressure visually
7. Check for any fluid and oil leakage
8. Check the connections
Weekly or every 50 hours:
1. Lubricate all the points specified in the
lubrication table
Every 100 hours:
1. Clean the engine air filter (*)
2. Check the battery fluid level
3. Clean the breather area on the oil tank
4. Check the condition of the power trans-
mission equipment
5. Clean the cab air filter
6. Check the gearbox oil level
7. Check the light functions
8. Check the oil level in final drives
9. Drain water out of the water separator
10. Check the brake functions
11. Check the belt tension
12. C l e a n t h e w i n d o w s
(*) or when the blockage indicator alarms
Every 500 hours:
1. Change the engine oil and filter.
2. Check the drive pedal function.
3. Run the additional heater and air
conditioning outside the heating season.
4. Replace the hydraulic oil filters after the
first 500 operating hours.
5. Check the screw tightness after the first
500 operating hours, particularly in the
crane and the joint.
6. Adjust the diesel engine valves after the
first 500 operating hours and then every
1000 operating hours.
Every 1 000 hours:
1. Change the fuel filter (*)
2. Change the fuel pre-filter (watersepara-
tor (*)
3. Drain condensed water out of the fuel tank
minimum once a year
4. Change the oil in the crane turning motor
5. Change the hydraulic filters (**)
6. Change the gearbox oil
7. Check the hydraulic hoses. Replace the
hoses at least every 15 years.
8. Check the radiator and engine air hoses
visually, replace if necessary.
9. Change the engine cooling water hoses at
least every five years.
10. A d j u s t t h e e n g i n e v a l v e s
(*) or when indicated by service code in the engine system
(**) or when the blockage indicator alarms
Every 1 500 hours:
1. Change the oil in final drives
2. Change the hydraulic oil
3. Check the signal light functions
Every 2000 hours
1. Inspect and clean diesel engine injectors
(EEM3 service tool)
Every 4000 hours
1. Inspect compressor clearances / check the
cleanliness of the intercooler
Every 6 months:
1. Service the fire extinguisher
Every 1 year:
1. Check/ service of the automatic fire
extinguishing system
Every 2 years:
1. Replace the AC drying cartridge
2. Change the engine coolant