Samlexpower 100S-12A, Instructions Manual

Page: 17 / 26

Sine Wave lnverter Connecting the inverter
6.3 Installing the inverter
Adjust the inverter to the chosen installation place and mark the fixing
points.
Fix the inverter by using the self-chosen fixing method.
7 Connecting the inverter
7.1 General instructions
In case the inverter is installed into vehicles or boats it has to be con-
nected to the chassis (ground).
 On building up an electricity supply network the safety regulations
according to the VDE 0100 standard are to be kept.
 Observe the required cable cross section (see table).
7.2 Connecting the inverter
Lay the flexible connecting cable (plus and minus) from the battery to
the connecting poles of the inverter (fig. 6, page 3 / fig. 15, page 8).
Warning!
Make sure that the the connection is not polarity reversed. Reverse
polarity connection will blow the internal fuses. It requres the expert
to change the fuses.
Bind the cable and the terminal firm and well together.
(fig. 5-1, page 3/fig13-1, page 7)
Fisrt connect the negative cable to the white negative terminal.
(fig. 6, page 3 / fig. 15, page 8)
Install a DC fuse or a breaker in the positive side of the circuit within 18
- P16 -
Device Required cable cross section
60S-12A/E 25 – 50 mm²
60S-24A/E
100S-12A/E 35 – 50 mm²
100S-24A/E
150S-12A/E 50 – 70 mm²
150S-24A/E
200S-12A/E 50 – 85 mm²
200S-24A/E