SAMES KREMLIN
Page 6
Manual : 573.005.212
Position offset correction :
Select "sensor position Regulex A"
display : xx mm
By means of a screwdriver, lift up the end of
the potentiometer (13) that is on the
lubricator ring (28) and raise it to the top of
the light.
The value of that position must be
contained in 0 to + 4 mm to make the
validation possible (otherwise, fault of the
movement sensor).
xx mm +
key
position 0
Important :
Dimension of the position sensor with lock-
nut (sensor to stop) :
- Regulex® proportioning machine, type
compacted : D = 69,5 mm
- Regulex® proportioning machine, type
reinforced : D = 123 mm
Example above : proportioning machine,
version compacted 5cc
PRIMING STAGE
When starting-up for the first time, ypu must prime the REGULEX® proportioning gun :
Come to move down the REGULEX® gun piston to low position.
Pressurize the filling pump.
WARNING : the fluid pressure at the inlet of the REGULEX® gun must
be lower or the same than the maximum pressure of the REGULEX®
(refer to REGULEX® features).
An overpressure must lead to a bad operating of the equipment.
Pressurize the filling and exhaust valves (maximum 6 bar / 87 psi).
The filling and exhaust valves are open.
The fluid is forced through the hoses then through the REGULEX® chamber.
Let the fluid flow out from the outlet of the REGULEX®.
Close the REGULEX® valves.
End of the
PRIMING
operation, beginning of the
WORKING
operation.
The working operation consits of 3 functions :
FILLING - REGULATION - EXTRUSION.
FILLING STAGE
The exhaust valve is closed.
The filling valve is open.
The REGULEX® gun chamber is filled by servo-controlling the ascent of the piston to the pressure
of the chamber.
