Operation and decommissioning
582118110-EN-indG-Regulator-PaintCare-BPR-L.docx
39
8.2
Mandatory checks before and during operation
Familiarise yourself with the work environment before starting work.
Inspect the equipment visually for noticeable defects at least once a
day (visual inspection). Follow the intervals for inspections and
maintenance
Before turning on the equipment, take note of any irregularities in the
area of the complete system. The following characteristics point out
to irregularities:
Increased noise level or irregular / unusual noises.
Unusual odours.
Smoke development.
Stains of the medium conveyed (ink, solvent etc.) at the
equipment or on the ground.
Conveyed medium is escaping.
Change of the control behaviour.
Shut down the machine immediately in case of first signs of the
characteristics mentioned before. Immediately notify maintenance
personnel for a precise assessment of the technical state.
The maintenance personnel has to decide whether the operation
can be continued without further restrictions of the functionality of the
equipment. Initiate repair measures immediately when a failure can
be anticipated from the determined damage.
8.3
Switching on
Pneumatic material back pressure regulator:
Set the outgoing pressure at the compressed air controller to
a minimum.
Switch on compressed air system and slowly ventilate
device.
Switch on medium conveying system and very slowly
increase volume flow.
Set back-pressure at material back pressure regulator via
the outgoing pressure at the pressure regulator
PaintCare BPR-L®.
The material back pressure regulator PaintCare BPR-L® is
ready for operation.