00-6
HOW TO CONSULT THE MANUAL
1.
Removal and refitting of assembled units
(1) For the removal or refitting of assembled units, the sequence of operations and the methods to be applied are de-
scribed in the removal procedure; if the refitting sequence of operations is the exact reverse of the removal pro-
cedure, it is not described.
(2) All special techniques that apply only to the refitting procedure are indicated by the symbol
; this same
symbol appears at the end of each major step in the removal procedure to indicate the parts for which special
techniques are to be applied during refitting.
E.g.:
REMOVAL OF UNIT
: ................................................ Operation heading
: ............................................................................. Safety rules to be observed when carrying out the pro-
cedure described
1 - Remove part (1):...................................................... Step of the procedure
★
: ................................................................................. Technique or important information regarding the re-
moval operation.
2 - Disconnect (2)
.........
: ...................................Indicates the existence of special information regar-
ding refitting of the component in question.
..........
ᐉ
: .............................................................. Recover oil, liquid or fuel and the quantity to be recov-
ered
E.g.:
REFITTING UNIT:
...................................................... Operation heading
·
Refitting is the reverse of removal
:.......................................................................Technique to be applied during refitting
★
: ................................................................................. Technique or important information regarding the refit-
ting operation
·
..........
ᐉ
: ............................................................ Filling with oil or liquid with quantity
2.
During removal and refitting operations, in addition to the general safety rules, you must also apply the specific
«SAFETY PRECAUTIONS FOR REMOVAL AND REFITTING OPERATIONS».
Always adhere to these precautions.
3.
List of special tools
(1) For details regarding the type, code numbers and quantity of all the tools (T1, T2, etc.) specified in the operating
procedures, see the heading «SPECIAL TOOLS».
4.
Tightening torques
1 - In the operating procedures, the symbol
denotes a specific tightening torque that has been determined ex-
perimentally and that must be adhered to.
2 - If the symbol does not appear, the torque values to be used are those indicated in the table in Section 00 of this
manual.
1
1
1
HOW TO CONSULT THE MANUAL
Find manuals at https://best-manuals.com
