Doc.-ID: 160720-PT08BA-SS-ExCam IPP5635_en_rev.00.docx, page 14 of 24
The green patch cable SKDxx disposes of 8(+1) conductors used for the data transfer
with other network devices as well as to power the camera. In order to guarantee the
power supply (Power Device, PD) of the ExCam IPP5635 (power device, PD) a Power-
over-Ethernet component (Power Sourcing Equipment, PSE) has to be available at the
connecting side (e.g. a PoE Switch, a PoE Injector, or Midspan) which meets the specifi-
cation IEEE 802.3at with class 4 (HiPoE, PoE+ (30W). A 100 Mbit Ethernet Connection
(100BASE-TX) is used for the ExCam IPP5635 data transfer.
In case the camera disposes of a plug, (figure 5.4); it has to be plugged into the RJ45
PoE slot of the network device. Due to the design, a faulty connection or pin assignment
is not possible. The network device can already be supplied with power, prior to connect-
ing it to the camera, hence there is no „power ON“ priority which has to be observed.
In case the ExCam IPP5635 disposes of a terminal block termination, the correct connec-
tion of the individual pins in accordance with EIA/TIA-568B has to be observed (q.v. table
5.2). Generally, the pins of the same color code are connected. Only use SAMCON ap-
proved clamps!
It is allowed to separate the ExCam IPP5635 from the network and to switch it on again
while in operation or in interaction with a visualization, video management system or
while accessing the web inteface (hot plugging).
Attention: „Hot plugging“ as well as the connection and separation of the data and
power cable SKDxx with/of network devices and terminal blocks under power is
only allowed within the safe area (non-hazardous atmosphere)!
The pin assignment of the SKDxx according to EIA/TIA-568B standard for 100BaseTX
with PoE (IEEE 802.3at) is done as follows:
Pin / Potential
Color
SKDxx
(IEC60757)
Plug /
pin contact
(TIA-568B)
Cross sec-
tion area
Remarks
Mode A
Mode B
Tx+ / PoE ±48 VDC Tx+
WH / OG
1
0.32 mm
2
Solid conductor
Tx- / PoE ±48 VDC
Tx-
OG
2
0.32 mm
2
Solid conductor
Rx+ / PoE GND
Rx+
WH / GN
3
0.32 mm
2
Solid conductor
n.a.
PoE +48 VDC
BU
4
0.32 mm
2
Solid conductor
n.a.
PoE +48 VDC
WH / BU
5
0.32 mm
2
Solid conductor
Rx- / PoE GND
Rx-
GN
6
0.32 mm
2
Solid conductor
n.a.
PoE GND
WH / BN
7
0.32 mm
2
Solid conductor
n.a.
PoE GND
BN
8
0.32 mm
2
Solid conductor
shield/ GND
(complete conductor bunch)
BK
9
2.5 mm
2
Shield braid of
tinned copper
wires Ø=0.13 mm
(AWG 36)
shield
(single, twisted pair pins)
n.a.
n.a. / 10
n.a.
Aluminum syn-
thetic strapp,
twisted
