Doc.-ID: 200917-PT08BA-ES-ExCam IPP1280_en_rev.01.docx, Page 23 of 28
The
“AXIS IP Utility“ tool automatically recognizes all ExCam devices and visualises
them in the device list. It can also be used to manually assign a static IP address. For this
purpose, the ExCam IPP1280 network camera has to be installed in the same physical
network segment (physical subnet) as the computer on which the AXIS IP Utility is run-
ning. The network signature of ExCam IPP1280 is "AXIS P1280" (see Figure 7-1). MAC
address and serial number for clear device identification are also detected and displayed.
Figure 7-1 Axis IP Utility
7.3
Password/ Identification
The following user name is set at the factory:
root
The following password is set at the factory:
root
8
Maintenance / Modification
The applicable regulations for the maintenance and servicing of electrical devices in po-
tentially explosive atmospheres must be adhered to.
The required maintenance intervals are specific to the individual devices. The operating
company has to determine these intervals depending on the application parameters. The
maintenance tasks especially include examination of parts on which the ignition protec-
tion depends (e.g., proper condition of the casing, seals and cable entry points). If
maintenance measures are necessary they have to be initiated and/or executed.
Repairs may only be carried out with original parts of SAMCON Prozessleittechnik
GmbH. Damaged pressure-resistant housings have to be replaced completely. In case of
doubt, send the part in question back to SAMCON Prozessleittechnik GmbH.
Reparations concerning the explosion protection must only be carried out in accordance
with nationally applied regulations by SAMCON Prozessleittechnik GmbH or by an au-
thorised electrical technician authorised by SAMCON Prozessleittechnik GmbH. Rebuild-
ing of or alterations to the devices are not permitted.
ExCam IPP1280
AXIS P1280
