Doc.-ID: 200917-PT08BA-ES-ExCam IPP1280_en_rev.01.docx, Page 20 of 28
Caution: Danger of damage to the ignition-puncture-proof gap (DIN 13-2 /grade
min. 6H)!
Carefully put the housing cover onto a clean place. Be careful! Do not touch the
screw connection of the cover with your hand or clothes! The screw connection is
coated with
fat "OKS 403" or “Molykote® P-40” against mechanical stresses.
Caution: risk of contamination of the ignition-puncture-proof thread bylints, fluffs or
metal chips sticking to the fatty coat!
6.2.1
Hardware Reset
To set all the parameters of the ExCam IPP1280 (including the IP address) to default
values, you should run a hardware reset.
The parameters can be reset via the web interface or manually. If the camera placed in
the network can no longer be reached or its state is uncontrollable, the reset should be
performed manually. To do so, proceed as follows:
1. Disconnect the camera installation module (Axis P1280) from the power supply.
2. Press and hold the control button and, at the same time, connect the system to the
voltage supply (PoE).
3. Hold the control button pressed for about 30 seconds.
4. Release the control button. After about a minute, the AXIS P1280 will return to fac-
tory defaults. If there is a DHCP server in the network, the IP address will be the
following: 192.168.0.90 (subnet masking 255.255.255.0).
5. IP address and password can be redefined. If the hardware reset is not satisfacto-
ry or the network camera shows serious conflicts or does not work as usual (errors
in the browser visualisation, frozen images, control commands no longer pro-
cessed, slowing down of the system, etc.), it may be necessary to re-install the
current firmware, or to install an update.
6.2.2
Removing / inserting a SD memory card
Note:
The ExCam IPP1280 has a slot for a micro SDHC memory card (card not included).
Saved video files can be played and deleted via the web interface. They are also availa-
ble in a download list. Moreover, the videos available in the memory card can also be
accessed via FTP server in the network.
If the memory card has to be replaced by the user, it should be, as far as possible, empty
and pre-formatted with an ext4 or vFAT file system.
When touching electrical components, observe potential equalization
(grounding of the body): carry electrostatic-discharge clothes, a PE
wristband etc.!
