SaMASZ XT 390, Operator'S Manual, Page: 35 / 48

35
OPERATOR'S MANUAL REAR DISC MOWER XT
7.4. Swath width adjustment
Swath width is adjusted with swath guides ( 1 ) mounted on the 3-point linkage frame of
the cutterbar ( Fig. 28 ).
In order to adjust the guide, the following should be performed:
❑
loosen
locknuts ( 2 ) and screws ( 3 )
,
❑
shift the guide arm ( 6
),
❑
tighten screws ( 3 ) and locknuts ( 2
),
❑
loosen locknuts ( 4 ) and screws ( 5
),
❑
then adjust height and shield angle ( 7
),
❑
tighten screws
( 5 ) and locknuts ( 4 ).
Fig. 28. Adjustment of swath guides: 1 - swath guide, 2 - locknuts, 3 - arm adjustment screws, 4 – locknuts,
5 - shield adjustment screws, 6 - guide arm, 7 – shield
Tab. 7. Torque values for bolts
In the absence of specific torque values, the following chart can be used as a guide to the
maximum safe torque for a particular size and grade of fastener. There is no torque difference for fine
or coarse threads. Torque values are based on clean, dry threads. Reduce value by 10% if threads are
oiled before assembly.
6
4
5
2 3
1
7