SaMASZ XT 390, Operator'S Manual, Page: 31 / 48

31
OPERATOR'S MANUAL REAR DISC MOWER XT
6.2. Removing clogging and jams
When operating the mower pay attention to variable conditions on field, which may influence the
mower clogging and jams, such as: terrain unevenness, height and density of grass as well as other
objects in the grass (stones, branches, piles of soil). In order to avoid clogging and jams, operating
speed should be adjusted to the mentioned conditions.
WARNING!
Removing clogs and jams while the machine is in operation can lead to the
accident !
In order to remove the machine clogging, lower the cutterbar onto the ground, disconnect the
drive and the motor, take out the ignition key and pay particular attention. Remove excess material
using sharp tool. After clearing the machine check if nothing has been damaged. When eliminating any
clogging on the machine, use also safety means for operator, so protective gloves and tight wear.
6.3. Dismounting machine from the tractor
WARNING!
When dismounting, make sure there is no person in between the machine
and the tractor.
To dismount the machine from the tractor:
❑
left the swath,
❑
deactivate cutterbar drive, ignition of tractor and removing the key of the tractor’s ignition lock ,
❑
reduce the pressure in the working system by press the button ( 3 ) on the control panel
( Fig. 16 ), at the same time it is reducing the pressure in the tractor's hydraulics,
❑
lift the machine so it is possible to insert support feet and secure them with cotters,
❑
lower the mower by means of the tractor's hydraulic assembly and place it on a firm and level
ground,
❑
protect the tractor against free runaway,
❑
dismount tractor's rpm and place it on a PTO shaft holder, that is standard-delivered with the mower,
❑
disconnect hydraulic hose and electrical installation from the tractor,
❑
disconnect the upper link C ( Fig. 11 ),
❑
disengage the machine from hangers of the tractor's lower links W ( Fig. 11 ) by lifting the three-
point linkage,
❑
carefully drive the tractor away.
6.4. Storing machine
The mower should be stored on a hard, flat and level surface, under dry, roofed place to protect
it from atmospheric precipitation. In order to save storing area e.g. under shed, houses, etc. the mower
may be stored in vertical position (
Fig. 22 ) but always on paved surface. Storing the mower on an
unpaved surface is inadmissible, for it may cause the mower to lose stability and in consequence lead
to falling for what the manufacturer shall not bear any responsibility.