Operator's Manual
Round bale wrapper
Spin S, Spin F
- 29 -
Fig. 31. Film cutting
A properly set cutter cuts the film when the unloaded bale touches the ground.
When the angle is too steep, the film is not cut even though the bale is unloaded to the
ground.
WARNING!
Lower the control lever on the hydraulic control unit when there is danger
caused by the wrapping machine. Turn off the tractor engine, remove the
ignition key and engage the tractor parking brake. Locate the hazard and
remove it.
WARNING!
Lock the rotary table during loading and unloading of the bale.
WARNING!
Take extra caution when adjusting the cutter. The cutter is extremely sharp.
Danger of hand injury.
Side wheels located on the sides of the rotary frame prevent the bale from falling off the
drums while wrapping.
8.5.2. Bale vertical positioning system – optional equipment SPIN S model
As optional supply, a bale vertical positioning system is available. This device allows to
position the wrapped bale vertically during unloading, in order to properly place it in the silage
storing location. By doing so, we eliminate the risk of damage to the film during transport from the
wrapping location to te storage location. This element may be purchased together with the machine
or at a later, convenient date. The positioning system allows the placement of bales on the left or
right side of the wrapping machine. The bale vertical positioning system is installed in a way shown
on the Fig. 32.