Operator's Manual
Round bale wrapper
Spin S, Spin F
- 25 -
WARNING!
Be careful while changing the position of the side wheel. There is a risk of
the operator’s hand being crushed.
8.4.2.
Wrapper SPIN F
To prepare the machine for work the wrapping machine drawbar needs to be placed in its
working position following the diagram bellow Fig. 26.
Fig. 26. Preparing the machine to work – a) transport position; b) working position
Set to the working position with a drawbar coupled with the tractor transport hitch.
Proceed as follows at changing the drawbar position:
Aling the coupled wrapping machine with the tractor axis,
Remove the drawbar security pin (back part of the drawbar),
Lock the right road wheel of the machine,
Slowly move the tractor with the machine forward until the security pin is in the working
position sleeve axis,
Lock the drawbar in the working position with a pin,
Unlock the loading arm,
Unlock the unloading unit,
Place the loading arm and unloading arm locks in the specified places.
WARNING!
Be careful while changing the position of the side wheel. There is a risk of
the operator’s hand being crushed.
8.4.3.
Bale loading
Lower the loading arm to its maximum lower position i.e. horizontal position when it is approx. 4"
above ground in its maximum deflection. Place the rotary frame perpendicular to the driving
direction so that the film cutting cutter is in front of the machine. Stop the rotary table about 25°
beyond the axis parallel to the wrapping machine axis and move the table back using the control
switch lever to a position parallel to the machine axis until the rotary table is locked. Move towards
the bale as shown in the drawing below Fig. 27 and
Fig.
28
.
NOTE:
The tractor approaching the bale should drive paralel to the bale’s axis so that
the axis of the loading arm faces the axis of the bale being loaded (SPIN S).
NOTE:
The axis of the wrapping machine moving forward should be perpendicular to the
loaded bale axis and the lowered arm should hold the bale (SPIN F).
a)
b)