Operator's Manual
Round bale wrapper
Spin S, Spin F
- 15 -
Fig. 15. Drawbar set for connection with the upper hitch
Change the position of the transport hitch in the following way:
o
Undo the four nuts and remove the M16 bolts,
o
Rotate the transport hitch by 180°,
o
Place the M16 screws in the openings and tighten them,
o
Unscrew the M12 screws holding the hitch-ring,
o
Rotate the hitch-ring by 180°,
o
Tighten the M12 screws fixing the hitch-ring.
Level the wrapping machine by selecting the appropriate adjustment opening in the hitch.
Connect the hitch-ring with the upper hitch. Check if the coupling is properly connected and
secured against accidental disconnection.
Connect the hydraulic power source. Check if the hydraulic systems work properly, especially
the lifting and blocking mechanisms responsible for controlling the working and transport
positions.
Make sure that the hydraulic system is sealed.
Connect the electric power source. Check if the operating and signalling systems work properly.
5.2. Disconnecting the drive
CAUTION!
Make sure that there are no bystanders, especially children, in the wrapping
machine’s storage area and its vicinity.
Place the wrappimg machine for storage on a hard, flat and level ground.
Turn off the tractor engine, remove the ignition key and engage the tractor’s parking brake.
Disconnect the electric power supply.
Disconnect the hydraulic system.
Lower the main frame support.
Disconnect the hitch-ring from the transport hitch.
Make sure that the machine will not move accidentally.