19
OPERATOR
’S
MANUAL
ROAD SHOULDER CUTTER
RP 110
The parts whose damage may pose threat to the ope
rator’s health and safety are: the working
tool and the damaged protective covers.
6.2.
After-season maintenance and storing
Carry out all
the actions in accordance with the section: “Maintenance and storage”.
7.
MAINTENANCE AND STORING
After disconnecting the road shoulder cutter from the extension arm, if the cutter is not used for
more than one month, always perform the following maintenance activities:
❑
thoroughly clean the road shoulder cutter from dirt, then wash and dry it..
❑
if the road shoulder cutter requires any repairs, adjustments, replacement of seals, hoses, or
cables, these activities must be performed.
❑
remove the corroded areas and repaint the defects in the paint coating.
❑
protect the uncoated metal surfaces with a thin layer of solid grease, e
.g. ŁT –
43, or transmission
oil, mineral oil, or engine oil, e.g. 15W40.
❑
fill out or replace illegible warning and information signs.
❑
plug the connection ports of hydraulic hoses.
Store the road shoulder cutter in a horizontal position, in a dry and clean place which is
inaccessible to third parties or animals, on a flat, hard surface under a roof or other cover protecting
the cutter against weather conditions.
Before commencing work after the storage period of the machine, it is necessary to:
❑
check the technical condition of the hydraulic and drive systems in the same way as in the case of
daily maintenance
,
❑
repair any defects in the paint coating
,
❑
lubricate the machine
,
❑
check the condition of hydraulic hoses
,
❑
check the condition of screw connections, tighten or replace if necessary.
8.
TRANSPORT AND DELIVERY
During the transport, the machine must be placed in a position close to the operating position
with the mounting plate facing up. When the road shoulder cutter is secured in this way, wrap it in a
bubble wrap and secure it to the pallet with a fastening tape. Further movement of the machine
should be carried out with a pallet as an integrated whole.
To place the road shoulder cutter on a pallet, use a belt sling and a lifting device with a lifting
capacity not lower than the weight of the cutter.
CAUTION:
The person in charge of the machine's transport shall be responsible for
securing the danger area and performing the work.
