Operator's manual
Trailed disc mowers
KDC
- 41 -
Fig. 47.
Points of check and oil replacement in intersecting axis gears
To replace oil in gears:
Prepare an adequate tank for the used oil to be disposed,
Open fuel cap
B
and drain plug
C
(
Fig. 47
),
Drain oil from the gear,
Close drain plug
C
,
Refill the oil level until it is visible in the check opening
A
,
Close fuel cap
B
.
7.3.
Roller cog gear
Prior to commencing examination of oil level in roller cog gear unscrew bolts holding
protective housing. Prior to work commencement check oil level and in the gear, and if need be,
refill after removing the vent
A
(
Fig. 48
) in the upper section of the gear. Oil level is examined by
removing the check plug
B
on the gear's back wall. If the oil level is too low refill the oil until it is
visible in the check opening
B
. Oil level in gear: approx. 0.5 l. Oil level is checked after the
cutterbar is set horizontally on the ground. To drain the oil from the gear use plug
C
, found in lower
section of the gear's body.
Tab. 11.
Amount of oil to be filled in cog gear
Fig. 48.
Points of check and oil replacement in cog gear
Mower type
Oil volume
[l]
Oil type
Replacement frequency
All types
0,5
80W90
After first 50 h of operation and then after
next 500 h (or at least once a year)
A
B
C
C
A
B
B
A
A
C
C
