Operator's manual
Trailed disc mowers
KDC
- 34 -
NOTE:
Springs are selected by the manufacturer to suit a given mower model. Do
not swap the springs, and during repairs mount springs purchased according
to a symbol given in parts catalogue at adequate side of the machine.
Fig. 35.
Support springs (adjusting spring tensioning)
Fig. 36.
Support springs (left and right spring)
6.10.
Operating service
6.10.1.
Daily maintenance
Upon daily completion of operation the following should be performed:
remove grass, dirt and mud from the mower,
inspect all visible external parts and assemblies and their connection; all loosen screws shall be
tightened while worn or damaged parts replaced,
use high pressure water cleaning to wash the mower after each mowing , especially inside the
disc and the cutterbar, because grass with mud may cause premature wearing of bearings in the
hub of slide plate and on vertical shaft,
inspect condition of the cutterbar,
lubricate the PTO shaft telescopic tubes with STP grease,
if necessary, lubricate the other parts and assemblies in accordance with the lubrication
instructions (item 7).
Parts, which may cause risk to operator’s health and safety are as follows: damaged disks,
tarpaulin covers, worn or damaged hydraulic hoses, PTO shaft guides, worn knives and knife holder
pins.
L
Left
side
Right
side
