Operating manual
Rear flail mower on a pantograph
KBRP 160; KBRP 200
- 14 -
5.6.
Preparing the mower for operation
Before starting work please observe the above-mentioned instructions. Upon completion of
these tasks the mower is considered ready for operation and the following can be done:
gently lower the cutting unit until the coping shaft makes contact with the ground,
slowly turn on the rear PTO (PTO rmp should be 540) until the flail shaft reaches nominal
speed,
put the tractor in gear and commence mowing.
5.7.
Operation
5.7.1.
General information about mowing
a) In an urban setting, to ensure that the mower works without breaking, it is recommended that
a pilot, who will mark all obstacles, should walk in front of the mower.
b) While crossing roads, on pedestrian crossings or other permanent obstacles the mower must
always be raised using the actuator 5 Pic. 3.
c) In real life the user should use so called "common sense". In regards with this during intense
usage the cost of necessary service checks should be taken into account - see Warranty
conditions point 11.
d) After driving onto single bushes with diameters up to about 2 cm. the tractor should be
momentarily stopped until the mower can shred the bush completely and then slowly, in spurts,
move forward so that the cutting unit does not get clogged.
UWAGA:
For thick and high vegetation, stumps etc. use heavier machinery.
5.7.2.
Operating positions of the mower
Pic. 11. Operating positions of the mower
