SaMASZ AlpS 271, Operator'S Manual

Page: 19 / 42

19
OPERATOR’S MANUAL SNOW PLOW ALPS / OLIMP
5.1.3. Mounting AlpS Up H, Olimp Up H plow on a truck
Snow plow AlpS Up H, Olimp Up H can be directly mounted on vehicle's linkage. In order to mount
the plow on the vehicle the following should be performed:
❑
take hydraulic power supply cover off,
❑
connect main power supply 4-pin plug and steering panel,
❑
turn switch MOUNT on and while holding UP button lift the hitch up to required mounting height
(switch underneath power supply cover
Fig. 15 ),
❑
set the vehicle in position which enables plow to be mounted on, so that hitch holders are above
linkage connectors (
Fig. 14 ),
❑
lower plow's hitch onto vehicle's DIN linkage while holding DOWN button (switch underneath power
supply cover -
Fig. 15 ),
❑
set switch in WORK position and pay special attention as in such position the hitch falls down freely,
what may cause bodily injury,
❑
upon mounting of the hitch on DIN linkage, protect the connection with two M27 bolts ( Fig. 14 ),
❑
install control panel,
❑
put hydraulic power supply cover on.
Fig. 14. The AlpS Up H plow mounted on the track
ATTENTION!
The manufacturer does not bear any responsibility for machine’s damages
resulting from improper mounting to vehicle. Plow’s disconnection may cause
its damage as a result of a collision with the vehicle. Plow’s proper mounting on
linkage should be inspected periodically when operating .
Lifting plow up with use of control panel does not work if MOUNTING switch is
on, and switches should be set in WORK position .
Mounting of the set with switch in MOUNTING mode on may cause the battery
discharge .
Place hitch holders in
front linkage connectors
Protect hitch with bolts by
screwing to front linkage