294 • Integrated Payment Appendix
SAM4s SPS-300 Operator's & Programming Manual v1.34
DATE 5/24/2011 WED TIME 10:34
**** LOCAL BATCH STATUS ****
0 4 3 3 2.00 0 .00
CLERK 1 000065 00000
Local Batch Status Explanations:
(From Left to Right)
o
Batch Status C=Closed/O=Open/X=Incomplete
4
Batch Number
3
Batch Transaction Count
3
Batch Item Count
2.00
Batch Balance
0
Batch Forwarded Transaction Count
.00
Batch Forwarded Balance
Dial In Load/Dial Out Load
For Legacy DataTran equipment
:
If instructed by Datacap support, you can use these options to update DataTran software.
Choose Enable Dial In Load to allow Datacap to call the DataTran and send updates. Choose
Enable Dial Out Load to call Datacap to connect. You will be required to enter the phone
number and terminal I.D. (password) which will be given to you by Datacap.
For TwinTran
:
When a TwinTran is first installed, the dealer
must do a Dial Out Load through the IP
connection
. If, for any reason, the internet is not available, the device cannot be loaded. If it
is being installed at a location where the Internet is not currently operational and the customer
wants to use the dial out method for approvals, the procedure below must be done at a
location where the internet is working.
To load a TwinTran using a Sam4s register:
With the TwinTran connected to the register and an active Ethernet line, enter into the Dial
Out mode. At the Phone number field enter the number “1”. If the register uses the code
entry method for alpha characters enter the 3-digit code (049). At the Enter ID prompt, enter
the serial number of the TwinTran. Select Tone phone connection. The TwinTran will call
Datacap’s host PC and load itself. This takes approximately 20 seconds. After the TwinTran is
loaded, one successful credit transaction must be done. After that the unit can be connected as
the customer wishes.
Tip Operation
Follow the prompts to enter the record number, original transaction amount and tip amount.
If the record number and transaction number are valid, the tip amount is entered in the batch
and a tip entry chit prints.
See Explanations
Summary of Contents for SPS-300 Series
