TESTING/PAIRING
TESTING/PAIRING
By changing the Setpoint temperature, you are permanently altering your temperature. You can change the
set point temperature very easily while you are reviewing the set point temperature. Press the UP or DOWN
keys repeatedly to change the temperature setting. The set point temperature will flash to indicate that it can
be changed: the temperature will be changed in 0.5°C steps per key press.
The RT310 will return to Normal mode if no keys are pressed for more than 2 seconds. Once the new Setpoint
is implemented, the change is permanently overridden until a new Setpoint is set again. Setpoint temperature
cannot be changed if Frost Protection mode is enabled.
TESTING/PAIRING
TESTING/PAIRING
Actual room temperature
Setpoint temperature
2 seconds timeout
Actual room temperature
Frost Protection
Press FROST button to activate Frost Protection.
The Setpoint temperature is automatically set to frost setpoint to prevent pipes from freezing. If the room
temperature is lower than the frost setpoint, frost protection will be enabled. When Frost Protection is enabled,
the user should not be able to press or adjust frost Setpoint temperature, this feature being accessible only in
installation mode. Please refer to page 7 on more information on Installer Mode. Press FROST button again
to de-activate Frost Protection.
TESTING/PAIRING
TESTING/PAIRING
Actual room temperature
Frost Mode activated
TESTING/PAIRING
TESTING/PAIRING
Actual room temperature
Frost Mode deactivated
Frost Protection ON
Frost Protection OFF
Note:
The setpoint frost temperature can be reviewed by pressing the Up button once, but can only be
changed in Installer Mode. For more information about entering Installer Mode, please refer to page 7
TESTING/PAIRING
TESTING/PAIRING
Frost Mode activated
Frost setpoint temperature
Adjusting Setpoint Temperature
10 RT310 Installation Manual
