ii
'
Salus
User'
Manual
'
S
AFETY'
I
NSTRUCTIONS
'
Please read these instructions carefully
before installing and using
the OPTIMA thermostat, and keep this guide in a safe place for future
reference.
•
Follow all local and electricity supplier regulations regarding the
installation or replacement of a thermostat. An authorized,
qualified installer may be required.
•
Do not connect any of the terminals to the 110/220 VAC
supply.
The OPTIMA thermostat uses two AA batteries or a 24
VAC power source.
•
Do not cover any of the vents on the thermostat.
•
Do not install this unit at an altitude over 2000 meters.
•
Do not place the unit in a bathroom or area of excessive
moisture. Do not allow the unit to get wet. This device serves as
a temperature control system only in dry, closed living and office
spaces.
•
Do not expose the unit to temperatures below 5
°
C or above
40
°
C, humidity above 80%, or pollution above
level 2.
OPTIMA'ZigBee'Thermostat'
33
'
'
FCC'and'Industry'Canada'
RF Radiation Exposure statement
: This equipment complies with FCC and
Industry Canada RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a
minimum distance of 20 centimeters between the antenna and all persons.
Industry'Canada'
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
