16
'
Salus
User'
Manual
'
The Fan Mode will change to indicate the current mode of the fan,
and the Fan Icon will appear when the fan is turned on. There will be
a slight delay between selecting Fan On mode and the fan turning on.
Press the FAN/HOLD button again to put the fan back into Auto mode,
under the control of the thermostat.
C
ONFIGURING'THE'
T
HERMOSTAT
Configuration Mode is for experienced or authorized installers
To enter Configuration Mode, press MODE for 3 seconds. The display
will clear and show a blinking
CLOCK
in the Label Area. In
Configuration Mode, after 20 seconds of inactivity, the thermostat
will exit Configuration Mode and return to the Home Screen.
Configuration'Menus'
Following are the functions that can be configured on the OPTIMA
thermostat. When a sub-menu option is selected, the thermostat will
return to the sub-menu title to indicate that the option has been
stored. The + or – buttons can be used to select another menu item
at the same level. To return to a higher-level menu item at any time,
press the FAN/HOLD button.
OPTIMA'ZigBee'Thermostat'
13
'
'
U
SING'THE'
T
HERMOSTAT
'
The OPTIMA thermostat offers basic functions from the local controls,
such as changing the Set Point and turning on the fan. To conserve
energy and minimize distractions at night, the display backlight
automatically turns off if no buttons are pressed within 10 seconds.
Changing'the'Set'Point'Temperature
There are two ways to change the set point temperature, using the +
or – buttons, or the slider ring.
From the Home Screen, the first press of the
+
button will move the
set point temperature to the large temperature display and blink the
display. Each press afterwards will increase the set point by 0.5
degrees. If the set point is not changed further within three (3)
seconds, the flashing value becomes the new set point temperature
and the screen returns to the Home Screen.
Similarly, from the Home Screen, the first press of the – button will
move and blink the set point temperature, and each press afterwards
will decrease the set point by 0.5 degrees.
