Saluki SFS-7000 Series, User Manual

Page: 59 / 63

47
Error message Reason Solution
Left/right fiber
place error
The fiber end-face is placed
on the electrode centerline
or beyond it.
Press RESET, and set the fiber and
end-face between the electrode centerline
and the V-groove edge.
Pushing motor
surpass limit
The fiber is not correctly
placed at the bottom of the
V-groove.
Press RESET, and put the fiber correctly.
Fiber end face in
touch
1) The value of overlap is
set too low.
2) Motor is not calibrated.
1) Adjust [overlap] parameter.
2) [Motor calibration] maintenance.
Fiber tracking
failed
1) The fiber is not put
correctly at the bottom of
the V-groove.
2) The fiber is not located
in the camera’s field of
view.
3) The cleaved length
(bare fiber part) is too short.
1) Press RESET and replace the fiber
correctly at the bottom of the V-groove.
2) Check the position of stripped fiber on
the fiber cleaver.
3) Check the cleaved length.
Cleave angle
abnormal
1) Bad quality of fiber
end-face.
1) Prepare fiber again. If problem
remains, check the condition of the blade.