47
Too thin
1) Discharging strength
not suitable.
2) Some discharge
parameters are not
suitable.
Adjust [splicing
discharging strength]
[discharging time] or
increase [overlap
amount].
Splicing line
Some discharge
parameters are not
suitable.
Adjust [splicing
discharging strength]
[discharging time] or
increase [overlap
amount].
Attention: when splice different types of fibers (different diameter) or multimode fiber,
sometimes there will be an upright line on the splicing point, we call it [splicing line], this
doesn’t influence the splicing quality (splicing loss and splicing strength).
10.2 Common error and solutions
When using fusion splicer, if there is error reminder, please refer to the following
solution. If problems still cannot be solved, then please contact the distributor for
help.
