BEFORE FIRST USE
1. Remove all packaging and tape. Make sure that you have the Ice Basket,
Ice Scoop and extra Silcone Stopper before discarding packaging.
2. Place the Ice Maker on a solid level surface, away from direct sunlight and
other sources of heat, such as a stove, furnace and or radiators.
3. Position the Ice Maker so that it is 12” (30 cm) away from the wall on the
left hand side.
4. After positioning the Ice Maker, wait 2 hours before starting.
5. Wash the interior and the Ice Basket and Ice Scoop. See the Care and
Cleaning section.
6. Make 2 batches of ice and discard. NOTE: It is possible that the 1st and
2nd batch will have a slight odour because of the manufacturing process.
Subsequent batches will not be affected.
IMPORTANT NOTE:
In the event that the power to the Ice Maker is inadvertently disconnected dur-
ing the ice making cycle or there are alarm lights blinking on the control panel,
press the Power Button once so that it is blinking, then unplug the unit. Wait
a few minutes until the Ice Maker warms up and the ice has fallen from the
Evaporator Fingers. Empty the Water Tray by following the directions in #2 of
the Care and Cleaning Section. Wait 3 minutes then plug the Ice Maker into
the wall outlet. Follow the directions in the How to Use section.
4
Booklet_IM-2022_EN_Q7.qxd:Salton Booklet 8/8/11 11:00 AM Page 4
