Figure 6
3. Place the Trolley up-side down. Push the frame into its correct position and ensure the cells are parallel
(Figure 7).
4. Now tighten the nuts that fasten the cells to the frame (refer to section 2.2.3 and 2.4.3). Torque to 100kg.
5. Fit the rear (and front) wheels.
Figure 7
2.5
Connecting the cells to the PCB.
The front and rear cells are wired to the PCB board located on the front axial cover.
1. Solder the front load cell at R1, B1, G1 and W1.
2. Solder the rear load cell at R2, B2, G2 and W2
3. Terminate the load cell screen onto the edge of the PCB.
2.6
Calibration
The scale will need to be re-calibrated. Please refer to Chapter 5
