4
S T A R T
S T O P
5
USER MANUAL
6 . 3 i n s t r u c t i o n s f o r a c o r r e c t O P E R A T I O N
1_ Check that the shampoo unit is correctly positioned on a flat lavelled surface and that it
is not wet or has signs of damage.
2_ Check that the working environment is suitable with correct lighting and correct
ventilation.
3_ Check that the shampoo unit is correctly connected to the hydraulic circuit so that warm
and cold water are available and it is possible to mix them to obtain the right temperature.
4_ Check that the water used to wash hair is correctly drained (check that the drainpipe is
not clogged).
5_ Check that the power supply cable and the plug are not damaged.
6_ Check that the socket’s power supply is 230 V at 50 Hz.
In case of anomalies during these checks, the operator should inform the person in charge.
7_ Put the plug in the socket.
8_ Lower the chair and the footrest as low as possible, using the appropriate push-button
panel key as shown in figure 2. Each key has to be held down to command the actuator
motion to make the downward movement begin. To stop the downward movement, release
the command key.
fig.2 Chair and footrest lowering
Lower seat
Lower footrest
Backrest in upright
position
Raise seat
Raise footrest
Backrest in
horizontal
position
EN
USER MANUAL
9_ Seat the client on the chair.
10_ Lift the footrest until it is in a horizontal position, and slide the backrest and seat.
11_ Lift the chair using the appropriate push-button panel keys as shown in figure 2, so
that the operator’s arms are free and he can take a natural position while washing hair.
Each key has to be held down to command the actuator motion to make the upward
movement begin. To stop the upward movement, release the command key.
12_ MASSAGE
If required, activate the massage using the appropriate button, see fig. 3.
fig.3 Massage control panel
EN
Each button must be held down to control the motion of the massage (both
activation and stopping) for one second. The one second hold pressure is
designed to avoid unwanted massage cycles.
The massage cycle lasts 3 minutes. If you want to stop the massage first, press
the stop button, as shown in fig. 3. In any case, after 3 minutes the massage will
stop autonomously.
