Salini SCC-5925B, User'S Manual & Installation Instructions

Page: 6 / 18

6
It is a requirement for the electrical system to be grounded according to the methods required by
the applicable regulations. Before the appliance is connected with the mains, assemble one full polar
breaker with over 3mm opened on the mains, and the rated current of the breaker is strongly recom-
mended over 40A. Please offer the power wire, which is up to the mustard (3*4 mm2), and let expert
install it in accordance with the figure shown.
Connect ground (yellow/green
one) to the place of ground mark; L
(brown one) to the place of five-foot
plug; N (blue one) to the place of
four-foot plug.
If a plug and socket are being used
make sure that they are compatible,
and are connected by means of a
power cable that complies to the
applicable regulations. The socket
must be accessible after the hob is
built in. Avoid the use of adapters
and shunts as these could cause
overheating and risk of fire.
If a fixed connection is being used, fit power line with an omnipolar circuit breaker with a contact
opening gap equal to or greater that 3mm in an easily accessible position in proximity to the cooktop.
If the appliance you have purchased is not fitted with a mains power lead. A power lead resistant to a
temperature of at least 90
°
C must be used. Otherwise, the electrical safety of the appliance may be put
at risk.
On first connection to the electrical mains, an operating check will be carried out automatically and
all the indicator lights will come on for a few seconds. Immediately after installation, carry out a brief
WARNING! This product must be installed by a licensed electrician.
INSTALLATION
• Any work on electric equipment and systems may only be carried out by a qualified electrician.
• Installer or qualified technician must carry out inspection and testing of the installed appliance.
• Means for disconnection must be incorporated in the fixed wiring, in accordance with the wiring
rules.
• Means for disconnection incorporated in the fixed wiring is in accordance with AS/NZS 3000
• WARNING: Always switch off the electricity supply at the mains during installation and during
maintenance to avoid the possibility of electric shock.
• Before installation, read all the instructions and make sure that the voltage (V) and the
frequency (Hz) indicated on your appliance data plate are exactly the same as the voltage (V) and
the frequency (Hz) in the system.
• Electrical data plate can be found on underside of appliance (Do not remove).
ELECTRICAL CONNECTION