Salini SCC-5925B, User'S Manual & Installation Instructions

Page: 11 / 18

11
INSTRUCTIONS FOR USE
RESIDUAL HEAT INDICATOR
Each cooking zone is equipped with a residual heat warning indicator. After any zone is switched off,
a flashing indicator may appear on the display. They are to warn that the cooking zone is still very
hot, extra care should be taken to avoid burns. Cooking can be restarted while the indicator is flashing.
TIMER
This model is equipped with a 1 to 99-minute cooking timer . To use the timed cooking function, first
turn on and set the power for the cooking zone. Then press the timer function symbol to set
the cooking time. Set the cooking time using the increase and decrease buttons. A red LED
indicator will turn on to indicate that it refers to that particular zone. After 5 seconds of setting the
time, the timer will start and the cooking zone will operate until the set time when the display above
the time symbol reaches 0.
It is possible to use the timed cooking function on more than one cooking zone. Once the timer is set
for the first cooking zone, select the next cooking zone by pressing the corresponding zone selection
button refer to the ‘CONTROL PANEL’ descriptions in the ‘COMPONENTS OVERVIEW’ section, and
set the time. When the timed cooking is active on several cooking zones at the same time, the display
will only show the time left on the first selected zone. For other zones, press the corresponding zone
selection button to display the timer for that zone.
To change the remaining time of a zone, you have to select the cooking zone then press the time
symbol to change the cooking time using the increase and decrease buttons.
LOCK OUT FUNCTION
The cooking zone lock-out function is a user safety function. It locks out the control panel to prevent
the cooking zones being switched on accidentally.
Hold down lock key for 1 second to lock out the control panel. The control panel can be reactivat-
ed by holding down lock key again for 1 second.
SWITCHING OFF THE COOKTOP
To turn off the cooktop press and hold down the power button for 1 second. This deactivates all
cooking zones even if they are in use or the lock-out function is active, and the cooktop will turn off
completely.
If the cooking zones have just been used, they will start flashing with the heat idicator a few
seconds after the appliance is turned off to warn that they are still hot.
OPERATOR ERROR
If the user makes a mistake when using the touch control buttons or is not following the operation
sequence, an error indicator appears on the power display, it will remain there as long as the user
continues to press the incorrect button. Please refer to the instructions to ensure the correct button
sequence is being used.