Salicru SPS SOHO+ series, User Manual, Page: 13 / 20

13
SALICRU
5. OPERATION.
5.1. Preliminary controls.
•
Make sure that all connections have been done properly, and
respecting the labelling of the equipment and the instructions
of chapter 4.
•
Check that the power supply is correct.
•
Check that the SPS is Off (shutdown).
•
Make sure that all loads are shutdown «Off».
Loads can be connected after the SPS start up and
one by one. Before shutdown the SPS, check that all
loads are shutdown (Off).
•
Check that the thermal protection of the equipment is not
tripped.
•
Turn “ON” the protection of the distribution panel.
5.2. Start up and shutdown.
To turn on the SPS unit, press the power switch lightly. To turn
off the SPS unit, press the power switch again (When switch ON
the LED lighting.).
Fig. 11.
Start up and shutdown.
5.3. LCD display.
The LED will always turns on when SPS works, including in off
charging mode and fault mode.
When LCD start to work, it will display all information for 3s:
INPUT (Unit: V AC)
LINE MODE (AVR)
OUTPUT (Unit: V AC)
FAULT
BACKUP MODE
BATTERY CAPACITY
LOAD LEVEL
Fig. 12.
LCD display.
•
When in normal mode, it will display as below.
Fig. 13.
Screen normal mode.
•
When in AVR mode, it will display as below. And the mark
will flicker every 1 second.
Fig. 14.
Screen AVR mode.
•
When in battery mode, il will display as below. And the
mark will flicker every 1 second.
Fig. 15.
Screen battery mode.
Note: If I/P-V < 40 V, input voltage will display “000”.
•
When in off charging mode, it will display as below.
Fig. 16.
Screen charging mode.
Note: The output voltage always is displayed as “000” in off
charging mode.
•
When in fault mode, it will display as below.
Fig. 17.
Screen fault mode.
•
Load level definition:
Load level Battery bar indication
0.. 25 %
25.. 50 %
50.. 75 %
75.. 100 %
Table 1.
Load level.