16
For devices ordered with a pallet and/or eyebolts, both only
on request, proceed as follows:
Lift the device using the eyebolts ‘
’
(CM)
with the me-
chanical means available, taking into account the weight
of the model indicated in the table below and without the
batteries, since these are not supplied pre-installed in-
side the system.
Remove the wooden pallet (
).
Before device and/or cabinet or battery cabinet installa-
tion in the final location, check that the floor is adequate
to support the weight.
If as a result of special backups or other specifications,
the weight of the battery cabinet is not shown in the table,
use as a reference the weight indicated on the packag-
ing’s
packing list
.
For batteries supplied on more than one pallet, add up all
of their weights.
For systems with rechargeable PbCa or NiCd accumu-
lators in which the battery trays are removable, fix it to
the floor using the holes located in the base
(BZ)
before
installing the batteries.
•
Together with the rectifier documentation, 4 trim screws are
supplied to replace the eyebolts
(CM)
in the cabinet systems
(only if optional eyebolts were ordered). Once the device is
installed or secured to the base or floor, they can be replaced.
6.2. Packing list and contents.
•
The number of cabinets varies depending on the device
model, with each one of them having an individual package.
In addition, it is necessary to consider that the batteries are
supplied packed on one or more pallets, depending on their
weights.
Check that the number of packages matches those indicated
in the packing list documentation.
6.3. Storage.
•
The device should be stored in a dry, ventilated room and pro-
tected from rain, dust, and water or chemical splashes. It is
advisable to keep devices and batteries in their original pack-
aging, as it has been specifically designed to ensure maximum
protection during transportation and storage.
•
The batteries are supplied packed on one or more pal-
lets depending on the model, separated from the DC
Power-L cabinet and/or battery cabinet itself.
Always take note of the diagram provided regarding every-
thing related to the polarity, position, orientation and connec-
tion of each battery and between batteries, as well as between
the accumulator bank and the system itself when they share
a cabinet.
•
Regardless of the type of accumulators used in a device, the
design life
of the batteries is regulated by the official Euro-
pean body EUROBAT, taking into account, among other char-
acteristics or conditions, temperature, float voltage, number of
charging and discharging cycles, depth of discharge, etc.
Because temperature is a very influential factor in the life ex-
pectancy of batteries, this body recommends that a storage
and operation temperature of 20ºC should not be exceeded
as far as possible, since the degradation will be significantly
higher
•
Before using a device with batteries in which the backup is
determined by accumulators, for the first time or after a long
period of time without use (maximum 6 months), it is neces-
sary to connect it to the power supply and leave the batteries
charging for at least 12 hours.
Although the unit can operate without charging them, consider
the risk of a prolonged power cut during the first hours of oper-
ation and the backup time or backup available for the device’s
batteries, which can be reduced.
USER MANUAL
Summary of Contents for DC POWER-L Series
Page 2: ...2 USER MANUAL...
Page 31: ...31 SALICRU...
