Salda SMARTY R V, Mounting And Installation Instruction

Page: 9 / 56

EN | 9 SMARTY RV v2019.12
Rotor box belt Rotor belt GNG00062
Smarty 2R VE door Door GNG00061
Rotor box motor Rotor motor ZVAR0133
Fan supply/exhaust
Fan
(Smarty 2R VER)
GPUVRA009
Fan
(Smarty 2R VER plus)
GVESMARTY001
Rotor box Rotor box GPURSD085_330
Temperature sensor 3 m TJ PJUT0063
Temperature sensor 1,5 m TL/TA PJUT0062
Controler MCB V1.0 ZED00985
Hall sensor Hall H1A-D12P24-1 PJUT0006
Electrical heater
SRR 0,6-1f EC-1k
(Smarty 2R VER)
ZESSRR028
SRR V-0,6-1f
(Smarty 2R VER plus)
ZESSRR032
5. INSTALATION
5.1. RECEPTION OF GOODS
Each device is thoroughly checked before transportation. When receiving goods it is recommended to check whether devices were damaged
&! _ -
sentative of the manufacturer, if any deviation from the order is noticed.
5.2. TRANSPORTATION AND STORAGE
• All units are packed in the factory to withstand regular conditions of transportation.
• Upon unpacking, check the unit for any damages caused during transportation. It is forbidden to install damaged units!!!
• The package is only for protection purpose!
• While unloading and storing the units, use suitable lifting equipment to avoid damages and injuries. Do not lift units by holding on power sup-
[[[$’“
"[>}@=” }†Z" "”?†”•}
°C. The place of storage must be protected against dirt and water.
• The units must be transported to the storage or installation site using forklifts.
• The storage is not recommended for a period longer than one year. In case of storage longer than one year, before the installation it is neces-
sary to verify whether the bearings of fans and motor rotate easily (turn the impeller by hand) and if the electric circuit insulation is not damaged
or the moisture is accumulated.
1200
mm
780
mm
2020 mm