17
4. Attach the 4 anti vibration feet to the pump (one per corner). Place a pump retainer
over 2 of the anti vibration feet. Repeat for the other side.
5. Position the pump so that the retainer fixing holes line up with the holes on the vessel
base. Insert the 4x fixings and tighten so that the pump is secure.
6. Connect the straight end of the vessel hose to the vessel port on the pump and connect the
angled end of the vessel hose to the brass vessel connector.
Note: a pumped unit should be installed after the stopcock and before any outlets. Any
outlets between the stopcock and the AccuBoost pump will not benefit from the AccuBoost
unit. If there is not space to install the pump and vessel by the stopcock, the pump can be
installed by the stopcock and the vessel installed elsewhere. Please note, in this scenario
the vessel outlet on the pump must be capped off and the vessel connected to the existing
property pipework. In this scenario, the overall performance of the system may be reduced.
7. Continue to follow the
Installation instructions
on page 6.
Figure 15
Figure 16
Figure 17