SAINT-GOBAIN Norton Clipper CS 451 D7, Operating Instructions Manual

Page: 16 / 32

VERS.2015.07.21 CS 451 D7_MAN_EN
16
3.4 Starting the machine
Make sure the blade is raised clear up the ground before starting the machine.
Set the speed adjuster to the STOP position, then move it to the START/RUN position, by
pulling the knob and stick it on the metal part. Never use starting sprays.
Pull the starting cable out by the handle until
you feel a slight resistance. Let the cable run
back; in this way the entire length of the
starting cable can be used to start the
machine. .
Grip the handle with both hands. Commence
pulling the starting cable vigorously and at an
increasing speed (do not jerk it violently) until
the engine starts.
If after several attempts of starting the exhaust begins to emit white smoke, move the speed
adjustment lever to the STOP position and pull the starting cable out slowly 5 times. Then repeat the
starting procedure.
To stop the machine, set the speed adjuster knob to the STOP position, and press it until the engine
cuts out.