8
3.4.2 Display Console Set Up
It is recommended to plug in the power supply to reduce the
battery consumption and extend the service life.
Note
: The sensor array must be powered and updating before
powering up the console, or the
console will time out searching for the sensor. Power the console last.
Make certain the weather station sensor array is at least 10’ away from
the console and within
100’ of the console. If the weather station is too close or too far away, it
may not receive a proper signal.
Remove the battery door on the back of the display, as shown in Figure
8. Insert three AAA (alkaline or lithium) batteries in the back of the
display console. The display will beep once and all of the LCD
segments will light up for a few seconds to verify all segments are
operating properly.
Note:
The character contrast is best from a slightly elevated viewing
angle.
Figure 8
