New Wind di Roberto Spata & C.
– Via V. Veneto, 2 – 22079 Villa Guardia (CO)
New Wind di Roberto Spata & C.
– Via V. Veneto, 2 – 22079 Villa Guardia (CO)
Tel. / Fax +39 031 563954, cell. +39 335 6645553 – e-mail:
Tel. / Fax +39 031 563954, cell. +39 335 6645553 – e-mail:
http://
www.nwind.it
- http://
www.sailbrain.it
http://
www.nwind.it
- http://
www.sailbrain.it
18
HOW TO APPROACH FOR RACING USUALLY:
These are the procedures usually used to start for a race:
1.
Startup your SailBrain;
2.
Set the length and the J of your boat and how you want to display all
the units of all measurement data refer to (to do only the first time
and before to go for the race): SETUP
→
UNIT;
3.
Set the screens of your liking during both the departure and after the
same (to do usually only the first time and before to go for the race):
SETUP
→
VIEW;
4.
Set if you want that SailBrain will indicate the starting line compass
degrees from the right estreme to left or contrary as soon as
countdown will start (to do only the first time and before to go for the
race): SETUP
→
VIEW
→
STARTLINEANG;
5.
Before to start make 2 or 4 close tacks and with the angle to the wind
which is the most similar as possible. SailBrain will autodetect the
wind direction at that time. If you want a check you can set yourself
the wind direction by pointing out it perfectly in the same direction of
the wind and watching the degrees of your compass direction: in this
last case not made detection of wind direction at a speed too low, and
if you made both the 2 close tacks and check properly you can see
that in SETUP
→
INPUT
→
WIND DIR direction is already set and
correct.
TIP: If you find discrepancies between the wind
direction detected by the tool during the tacks or if you don't
have enough time to do them, set the direction of the wind of
your check in SETUP
→
INPUT both in WIND DIR that BASE
WIND DIR;
6.
Set into SETUP
→
INPUT targets of your boat for a correct display of
the times to the starting line and layline.
7.
Set SETUP
→
RACE
→
WAIP
→
DIR/DIST distance and direction of
marks;
IMPORTANT: to correctly display data after departure it
is important to set the direction and distance of marks before
you start the timer;
8.
Place the right end of the starting line: RACE
→
PRE-RACE
→
START
RIGHT as previously shown;
9.
Place the left end of the starting line: RACE
→
PRE-RACE
→
START
LEFT as previously shown;
10.
If you want, you can make provisionally start the countdown: RACE
→
TIMER and
SailBrain will give you the compass direction of the
starting line from right to left end according to as you have previously
set.
11.
At this point you are ready to start for your race; wait for the starting
procedure and make your choices. Sail Brain will help you with its
graphical view that, depending on whether the line perfectly
horizontal or not, will indicate to you from which part of the starting
line it’s better to start. In this mode you can choose the emission
partial data (11.a) or the display of all data that SailBrain offers
(11.b) according to your previous choice;
12.
Immediately after the starting signal SailBrain will automatically be in
a mode (Race mode) that will expose data you deem appropriate in
accordance with the previously chosen settings. If you want to change
the following settings you just press the "ESC" button to modify the
desired settings;