ENGLISH
14. Health and Safety
In order to carry out maintenance, repairs or cleaning, first disconnect the unit from the
compressed air distribution network and feeding of product.and always tighten the lock*
(clockwise) until the needle does not move due to the action of the trigger.
* Safety system incorporated in later versions dated 2019/04
Safe disconnection from the product hose:
If there is any cleaning liquid or product remaining in
the tank, return it to its corresponding container. Depressurise the product hose properly and,
using a spanner, unscrew the end of the hose from the product inlet connector, holding the pistol
firmly.
Safe connection from the product hose:
Connect the hose to the pistol. Hold the pistol firmly and,
using a spanner, screw the end of the hose into the air inlet connector. Check there are no leaks.
Safe disconnection from the compressed air network:
If there is any cleaning liquid or product remaining, return it to its corresponding container. If the
pneumatic connector is fitted in the air inlet, disconnect the hose from the pistol. If it is not,
depressurise the air hose properly and, using a spanner, unscrew the end of the hose from the air
inlet connector, holding the pistol firmly, and if it is with fast connection click on the racord and
remove the hose.
Safe connection to the compressed air network:
If the pneumatic connector is fitted in the air inlet, connect the hose to the pistol. If it is not, hold
the pistol firmly and, using a spanner, screw the end of the hose into the air inlet connector or if it
is with fast connection, insert the hose into the hole. Check there are no leaks.
Never point the unit towards yourself, others or animals.
The thinners and dilution media used
can cause serious injury.
We recommend using this unit in premises with forced ventilation and in accordance with the
current standards and provisions on the matter
.
Near the unit
, only keep the amount of
product and thinner required for the work
being done at
that time. After work has been completed, thinners and the product to be applied must be
returned to their corresponding storage location.
Keep the working area clean
and free of potentially dangerous waste (thinners, rags, etc...).
While work is in progress, there must not be any source of ignition
(naked flames, lighted cigaret-
tes, etc.) in the working area as these might generate easily flammable gases. Likewise, the
approved protective means must be used (breathing, hearing, etc.) in accordance with the regula-
tions established in this regard.
If the unit is used in an inadequate manner or its components are altered in any way
severe
material damage may occur and bodily harm may be caused to the operator, other personnel
and/or animals and may even cause death.
SAGOLA S.A.
accepts no responsibility in for any
damage caused through the incorrect use of the unit.
Always use approved breathing units in accordance with current Standards and Regulations
in
order to protect yourself from emissions produced during application.
Never exceed the maximum air inlet pressure (2 bar)
. Excessive pressure will cause greater
environmental contamination. To provide the hose with compressed air for the pistol, fit a pressure
regulator and a safety valve.
As a general, preventive measure we advise you to wear goggles in accordance with the specific
environmental regulations and characteristics for the work centre.
Wear gloves when handling the product
(see the manufacturer's recommendations) and clean
the gun.
If, when the gun is in use, the ambient noise level exceeds 85 dB (A)
the use of approved ear
protectors is recommended.
