ENGLISH
· Control the application distance.
·
If sagging occurs
, this is due to the fact that the amount of
product to be applied is excessive for the air pressure used,
that the viscosity is not correct or the application speed is
not adequate.
Decrease the amount of product, adjust its
viscosity or increase the application
speed until the
required finish is obtained.
·
The spraying width
(spraying pattern) obtained
will
depend on the Tip used. If Tips are required for other
applications, contact the Technical Service of SAGOLA
S.A.
· Apply the product perpendicularly to the part.
7. Functional Description of the Equipment
· The SAGOLA gun model
MINI XTREME MIX
can be used for applying appropriately diluted
products used widely in the
timber industry, plastics,..
.
· The
MINI XTREME MIX
gun is a manual
MIXED gun
for
professional use
only.
· This gun can be mounted according to the working pressure: (Spring yellow up to 120 bar/1,740
psi or spring red up to 200 bar/2,900.6 psi).
· It’s a spray gun with adjustable fan pattern and a swivel fitting.
· Spray gun recommended for spraying: is suitable for
funds and finishes of 1K and 2K materials
in solvented or wated-based products
.
8. Start-up
Before each start-up and especially after cleaning or
repairing the unit, a check must be made that all its
elements are securely tightened.
1· Prepare the paint (blend and filter the paint to the
appropriate viscosity - refer to the material
technical data).
2· When assembling the equipment, make sure to connect
the air hose to the air inlet must be (clean dry air, maximum
air pressure = 2 bar / 29 psi) (1) and the product hose to
the product conduits (2).
3· Prime the pump (refer to pump instruction manual).
4· Select a spray nozzle refer to TIPS nozzle chart and
spring (yellow spring 120 bar / 1,740 psi or red spring 200
bar / 2,900.6 psi).
5· Make sure white seal or micro-filter is in place in the spray nozzle.
6· Install the spray nozzle inside the air cap being certain the locating pins is aligned with mating
recesses of the nozzle.
7· Unlock the security system. To do this, loosen up to the stop (counter-clockwise).
8· Insert the air cap with its nozzle into the retaining ring. Screw retaining ring and air cap firmly
onto the spray gun positioning the air cap to obtain the desired pattern orientation.
9· Point the gun into a waste container and and open the gun by using the trigger until clean
material flows.
OK
20-30 cm
Application distance
1
3
2
