Sagem Phonefax 2425, User Manual

Page: 53 / 56

44
Appendix
Caution - The gauge card displays on the screen, after each printing, the percentage of remaining ink ribbon. If
the gauge is not installed or not properly installed, the unit displays: .
❑
If you forgot to change the gauge at the same time as the ribbon, the unit displays: .
7
528%/(6+227,1*
MISSING GAUGE
GAUGE EMPT
)DLOXUHV 5HPHGLHV
• The screen remains blank. • Check that the power cord is correctly connected on both its si-
des.
• The machine does not answer the
call.
• Check the reception mode.
• Check the number of rings (please refer to § Number of rings
for the automatic mode on page 17).
• Configure the machine on "private network" (please refer to
§ Network on page 16).
• The printed photocopy is blank. • The document was placed upside down in the document feeder.
• The telephone exchange does not
recognise the number you have cal-
led.
• Check that the telephone line cord is correctly connected to the
device.
• Check the telephone line and the phone outlet.
• The machine does not ring. • Restore ringing (please refer to § Ringing melody and key
beeps on page 15).
• The telephone does not work. • Check that the power cord is correctly connected on both its si-
des.
• There may be a power failure.
• Check the telephone line and the phone outlet.
• One or several vertical black strips
appear on the documents copied or
received by your party.
• Open the front cover and clean the scanning device (analysis)
located in front of the white roller with a soft lint-free rag soa-
ked with alcohol. After cleaning, close the front cover and
make a copy to check that the black strips have disappeared.
• The gauge card housing has unclip-
ped.
• You may easily put it back into place: approach the gauge card
housing, striations downwards, and position both axes towards
the slots of the housing lower part, then push until clipping
(please refer to § Replacement of consumables on page 41).
The screen displays:
• Put paper into the paper feeder.
• Close the rear cover.
• Open the rear cover to access the paper path and remove the
sheet of paper. Make sure the rear cover is properly closed af-
terwards.
• The last printed documents show a lot of black smears, the
printer temperature is too high. Wait a few minutes for it to co-
ol.
• You probably forgot to replace the gauge when you replaced
the printer ribbon.
OUT OF PAPER
PRINTER COVER
REMOVE PAGE
OVERHEATING
GAUGE EMPTY
A
LIASSE 23260059-6 A (P).book Page 44 Vendredi, 2. juin 2000 3:41 15