32
Reset button
The button for restarting the device is located on the rear
side of the device. Use a pointed object (for example, a
straightened paper clip or a toothpick) to press the button.
Reset-Knopf Detail
Power Cycling
If a problem occurs that cannot be corrected with the in-
structions in this user manual (see also the help below), fol-
low the steps given here.
1
Pull out the power plug.
2
Wait at least ten seconds, then plug the power plug
back into the socket.
3
If the error occurs again, please contact our technical
customer service or your retailer. Follow the instruc-
tions on the display and on the error report.
General information
The time and date flash on the display.
You must check the time and date after a short power fail-
ure. Confirm using
OK
.
Problems when faxing or printing
Faxes sent are of poor quality.
Change the resolution from
RESOL.: STANDARD
to
RESOL.: FINE
or
RESOL.: PHOTO
.
Change the contrast.
Clean the scanner and the document feed slot.
Test the device by making a copy of the document. If the
device is in order, the fax machine of the recipient is defec-
tive.
The device produces black lines when sending or printing. Clean the scanner and the document feed slot.
Copy is blank.
Insert the documents face up into the document feeder.
Printing is interrupted.
Paper or document jam, no paper or ink film. Follow the
instructions on the display and in the error report.
There could be a small pause after printing several pages.
The device continues printing automatically.
No printing
Check if you have inserted clamped paper correctly. The
lever on the right hand side next to the paper feeder must
be folded backwards.
Documents are not properly fed.
Clean the scanner and the document feed slot.
Problems with the connection
The device rings once, remains silent for a short while and
starts ringing again.
This is absolutely normal. The fax switch checks the call af-
ter the first ring. If it is a voice call, the device continues to
ring.
No dial tone
Check the installation of the device. Connect the telephone
cable to the socket marked
LINE
. Insert the telephone plug
into your telephone connection socket.
