Procedure
Symptom
Test
Fiche Proc 4
01
M 2005
5(03/$&(0(17&211(&7(85
)21''(3267(
3/3
Before any operation,
-flux correctly the pins of the connector.
-with the solder wick loaded with tin , tin the pins
of the DATA/ AUDIO/ CHARGE connector by
positioning it straight ahead (pads upward), and
by heating the solder wick which is in touch with
pins.
$WWHQWLRQ
- At the end of the operation , verify that there is
no short circuit between pads.
-Start soldering the connector pins.
-Flux the place of the connector and position the
DATA/ AUDIO/ CHARGE connector.
-Verify that the pins of the DATA/ AUDIO/
CHARGE connector are well centred on pads.
-Heat pins with an air blow device while
maintaining the connector with tweezers
9HULI\WKDWWKHUHLVQRVKRUWFLUFXLWWKDW
VROGHUVDUHVKLQ\DQGWKDWWKH\FRYHUZHOOWKH
SLQV
At last, solder the 4 pins crossing the
REF MTB DTS 8- Indice B - February 21 2006
Page 5-30