Hose & Regulator Assembly And Replacement
1.
a.
If the burner valve is open prior to the LP gas cylinder service valve being opened, the
connection will interpret this free
flow of gas to be a leak.
b.
The connection safety feature will reduce gas
flow from the regulator to the appliance to a
minimal level.
c.
Be sure that the burner control valve is closed prior to opening the LP gas cylinder service
valve to ensure that the connection
flow limiting device is not triggered mistakenly.
d.
If the connection
flow limiting device is triggered mistakenly, close the LP gas cylinder
service valve and the burner valve, wait 10 seconds to allow the device to reset, open the
cylinder service valve, then open the burner valve and light the fireplace as per
lighting
instructions.
2.
Be sure to protect the hose from any hot surfaces. Serious danger may result if the hose
contacts any hot surface.
3.
Regular maintenance of the hose and regulator:
a.
Inspect the hose before each use of the fire table. If the hose shows signs of cracks,
abrasions, cuts or damage of any kind, do not operate the appliance. Fix or replace the hose
as required before using the appliance. Use only replacement parts from the manufacturer.
b.
Inspect the seal inside the v a l v e on the LP gas cylinder when replacing the cylinder or at
least once per year. If there is any indication of damage, have the seal replaced by a
certified
gas dealer before operating the appliance.
4.
Do not use tools to tighten the connection nut onto the LP gas cylinder service valve. Hand
tighten only.
5.
Be careful to not cross the threads on the connection when tightening the connection on to the
LP gas cylinder service valve.
6.
“Leak Test” should always be performed after attaching the connection to the LP gas cylinder service
valve. (See
“Checking for Leaks” section of this manual on page
12)
7.
For the connection of the hose and regulator to the LP tank, refer to the
“Connection” section
of the LP gas cylinder section above.
7
