3 / 8
Safire cera22 Ceramic cooktop
SF-Lämmitin Oy Tilhenkatu 1 20610 TURKU, FINLAND Tel. +358(0)2 244 3282
01/2018
Cooktops equipped with a heating blower lid
- The thermostat sensor is connected to terminal block X10. The electronics automatically
detect the installation of a thermostat sensor. When the blower lid is in the lower position, the
power control of the control panel changes to temperature control. Please note! Disconnect
the heater from the battery before connecting the thermostat sensor.
-
The pump’s power cords are connected to terminal block X10.
NOTE!
Connect all wires so that any water flowing along them will not end up on the circuit
board of the cooktop.
SIRIUS CONTROL PANEL
- The control panel should be located in a dry, splash-proof location so that it is easy to see and
use and there is no risk of accidental starting.
- The body of the control panel is first fixed with 2-sided tape, e.g. to the cabinet wall, and the
cable is passed through the wall. Lastly, attach the cover plate with 2-sided tape.
- The cable of the control panel is connected to the circuit board of the cooktop. The main
power is connected after the control panel is connected.
USAGE
COMMISSIONING
Make sure that:
o
The tank, tank connection and fuel line are properly installed.
o
The stove is securely attached.
o
The exhaust system is properly installed and there are no flammable substances
or objects in the vicinity of the exhaust passage.
o
There are no flammable substances or objects on the stove.
FUEL
-
The recommended fuel is HVO-based winter grade diesel (summer grade in summer), e.g.
Neste MY or Pro Diesel, and in extremely cold conditions paraffin oil (Neste or Polaric). At the
end of the season, it is recommended that you leave the winter grade diesel or paraffin oil in
the fuel line so that there are no start-up problems at the beginning of the next season. Poor
fuel quality is the most common cause of malfunctions in stoves and heaters.
-
Note that the recommended fuel storage times are not very long these days, at most about
half a year.
-
Only isopropanol (2%) can be used as an additive to remove any water and clean the fuel line.
