1 / 8
Safire cera22 Ceramic cooktop
SF-Lämmitin Oy Tilhenkatu 1 20610 TURKU, FINLAND Tel. +358(0)2 244 3282
01/2018
CONTENTS OF THE FACTORY PACKAGING:
- cera22 Ceramic cooktop, fasteners
- Fuel line (approx. 3m), pump
- Power cables (approx. 4m)
- Sirius control panel (approx. 2m cable)
INSTALLATION
INSTALLATION LOCATION
-
Provide ventilation at the installation location so that as the cooktop heats up, a natural air
circulation is created to provide ventilation. If necessary, exhaust air can be led directly
through the table top by using a ventilation grille for table tops.
-
There must not be any material above the cooktop that presents a fire hazard in the event of
the cooktop overheating.
-
You should be able to remove the hob for maintenance work. Some maintenance work (glow
plug, feed needle and flame sensor) and attachments can be done through a service hatch
located in front of the cooktop.
-
Install the control panel in a place convenient for usage (visibility and use of controls),
preferably on a vertical surface.
-
The cooktop heats its surroundings. This should be taken into consideration when choosing
the location of the refrigerator and the cooktop, for example.
INSTALLATION
- Saw a 443 x 300 mm mounting opening (height 200 mm) on the table top.
- Ensure ventilation underneath the cooktop by providing ventilation openings of approximately
100 cm
2
(=10x10cm) on the top and bottom of the installation space.
- Before mounting the cooktop, it is recommended to install the flue gas pipe (max. 3.5m).
- Mark the centre of the flue gas pipe, but ensure that there is enough space inside the upward-
pointing “
goose neck
” that prevents water from entering the flue gas pipe. The outlet of the
flue gas pipe must be located either at the rear of the side of the boat or in the stern at least
0.5m from the refuelling connection and the sea level.
- Dri
ll a 30mm hole to the boat’s structure and 4.5mm mounting screw holes using the through-
hull as a template. Apply silicone compound to both surfaces of the seal to ensure tightness.
- Mount the through-hull to a metal boat by using nylon screws in order to isolate the galvanic
contact of the battery and the hull (the cooker body is in contact with the terminal of the battery
and may cause malfunction or affect the galvanic corrosion protection).
- Lower the cooktop into the opening. Installation can be made easier by supporting the cooktop
e.g. through the service hatch.
- Attach the cooktop using the brackets. Adjusting the brackets allows installation on most table
top thicknesses (3-38mm).
- Connect the flue gas pipe to the cooktop with a hose band and insulate the pipe with a thermal
insulation sock if necessary.
- Sufficient extra length must be reserved for the cooktop power cable and fuel line for
disassembly and maintenance.
