Doc.# TS-TWHR-XXX
8001 Woodland Dr • Indianapolis, IN 46278 • Customer Service :Phone (800) 560-1094 • Fax (800) 560-1275
SafeWaze
®
Fall Protection
Technical Data Sheet
SWHR-XXX
SideWalk
30’,60’,100’ Rope Horizontal Lifeline Systems
1.1
Verify that the anchorages meet
the requirements per OSHA 1926 or
as described in these instructions.
1.2
Verify that the clearance below
the walking working surface is ade-
quate. (See previous Table 1 & 2.)
1.3
If the above parameters are ac-
ceptable and consistent with the ap-
plication, proceed with the installa-
tion.
1.4
Visually inspect the SWHR-XXX
before every use by user.
1.5
If needed, attach appropriate an-
chorage connectors to the anchor-
ages according the instruction pro-
vided with the anchorage connector.
Make sure that the anchorage con-
nectors are installed at the same ele-
vation and there is no more than 5
degrees of slope in the line.
1.6
Connect the end of the SWHR-
XXX with the spliced eye to one an-
chorage using the carabiner and
0247 setup as shown below.
1.7
Connect the 0246-HD eye of the
SWHR-XXX to the other anchorage
using the carabiner provided.
1.8
Open 0246-HD to allow pulling
the back spliced end of lifeline
through the 0246-HD by hand until
the slack has been removed and is
hand taut. Close unit.
Installation & adjustment of the 0246-HD Tensioner
1.9
Make sure release lever is in the
closed position.
1.10
Use a torque wrench to rotate the
0247-HD nut clockwise to a maximum
force of 60ft-lb. The recommended ten-
sion force on the line is 140-150 lb. DO
NOT OVERTIGHTEN.
1.11
Utilize the backsplice or use a knot
tied in end of rope to prevent rope from
coming back through the tensioner.
Note: The buyer is responsible for
ensuring proper strength and reliability of
anchorage points and for proper installa-
tion.
Eye
Unit open
to show path
of rope
Page 5 of 5
Rope from
other end
of lifeline
Rope is to be pulled through unit
in this direction after being se-
cured to anchorage on far end.
Pull hand tight, close unit cover,
and then tension per instructions.
Eye
Tension
Nut-turn
to put more
tension on rope
Use a wrench
or a cylindrical
bar to turn nut.
DO NOT OVERTIGHTEN.
To release
the rope tension
pull down on
on tension release
lever.
Set Max tension
350 lbs
