safety precaution HTP-T32G, User Manual

Page: 11 / 55

H.264 IP Camera Manual
11/4
1. Connecting Network (LAN)
z Connect a LAN Cable to LAN port of HTP-T13MG.
2. Connecting Audio
Audio is full-duplex. It is possible to set the mode as Tx-only, Rx-only or Tx-Rx.
z Connect audio input and output ports to audio devices accordingly.
z The Audio signal required is line level, so audio equipment with an amp, mixer or other amplifier
should be used.
3. Connecting Serial Ports
RS-485 of HTP-T32G can be connected to external equipment such as PT receiver etc. PC client can
send PT commands to the external equipment via the serial port.
When a decoder system instead of PC client is connected to HTP-T32G, the serial port and that of the
decoder system works in pass-through mode. That is, data from at one port is delivered to the other port,
vice versa
4. Connecting Sensor and Alarm
Connect sensor and alarm devices to corresponding terminals accordingly.
5. Connecting Power
After confirming the power source, connect power adaptor and connect the 12VDC connector to the
system.
INSTALLATION
2