For more help and resources, call 1-800-544-1108 or visit www.safety1st.com
19
18
Troubleshooting
Troubleshooting
Troubleshooting copy - TBD - See rough draft/Word Document
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
Changes or modifications not expressly approved by the party responsible for compliance coul
d void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
*Reorient o relocate the receiving antenna.
*Increase the separation between the equipment and receiver.
*Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
*Consult the dealer or an experienced radio/TV technician for help.
INDUSTRY CANADA NOTICES (IC):
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operationof the device
Avis d'Industrie Canada (IC):
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son
fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas
provoquer d'interférences et (2) cet appareil doit accepter toute interférence, y compris celles
pouvant causer un mauvais fonctionnement de l'appareil
RF Exposure warning:
The distance between user and product
include its antenna must
be no less than 20cm
during the normal operation.
La distance entre l'utilisateur et de produits ne devrait pas être inférieure à 20cm